From time to time I thought about cup holders, I have the rectangular tray thingy. I eventually concluded that the tray is a better option for me. I've made my own cupholder in the driver's door pocket by pushing in a plastic pottle. Not exactly...

Is this for a K series? If it is then I don't think you need remove the IRD support bracket.

I swapped out my fabric seats for a set of leather from a very tidy V6 being scrapped. Front seats are heated! The fabric set is in very good condition.

It has 340,000km on it :D

Drove it - 240+km Still a very nice car to get around in. Pleasing economy: 11.12 Km/litre - or 8.99 litre /100km

Held with Torx self tapping screws. All 6 are same size. Can measure one but about 3mm estimate.

An air rifle is less alarming for the neighbours than a shot gun. ;)

ABS sensor removed cleaned lightly lubed and refitted - pushed onto the reluctor ring and that backed off just a 'tad'. 3 amigos GONE. :) HDC works as it should... Very happy

I took the plunge today and took the FL1 to have the codes read. The prob I've got is that after fitting a replacement clutch I had the 3 amigos :( Managed to get 2 of them to 'go' but was left with the yellow HDC lamp on. I've recently replaced...

Done it. Like using the suede effect. Nice and thin and stretches. The best tip is only to glue about 12 inches, sorry 300mm at a time and take your time. Don't glue the edges until you are done and then the glue won't grab the fabric while...