What part of America are you in Chris ?
Do you know where the diff lock lever is on the LT230 (transfer box) ?
Have you removed the lever and used a spanner to turn it on and off ?
Are the wires connected to the diff lock switch (green and...
The new earth cable arrived in the post today from Devon 4x4. It was a large and quite heavy parcel for a small item, but this was due to the large catalogue that they posted with the cable! I fitted it but the chassis earth didn’t have any...
It has always had E5 (never E10) and I recently added Castrol Valvesaver at the last top-up which is a Lead Replacement and Octane improver.
Today I pulled the timing "All in" at 4,200 RPM back by 2 or 3 degrees to about 30° BTDC.
I am going out...
cylinders 1 and 2 share a port as do 3 and 4 so it doesn't make sense
If two and three are black then I can't think of a cure off hand
Maybe a plug problem, clean em off and swap them around see what happens
Still working through my (getting shorter) list of family and mates who want a ride in the 101. My nephew called in this morning. I was pre-warned so was checking the tyre pressures on it and the BM. The back two go down a few psi over a couple...
Are you using the chassis or reg number to find the part?
You will need to get that front pulley off.
(Allen key in middle & ring spanner,spanner may need a shock knock to start with)
Well that is the last of the ABS saga at least for a while!
New CV & Shaft. Lights came back... 🤷‍♂️
New sensor in lights gone!
Funny how the sensor lasted a year to the day! But its a 2 year warranty so will be going back to Island4x4 for a...
I’ve done the front pillars. You need to drill out the spot welds to get the old part off. Replacements are available from YRM. They recommend installing these using structural adhesive, obviously as most of us don’t have access to an aluminum...
Well, I tried the connector block with the multimeter and all shows well/ Then I put the light back on and the low beam failed; I then tried linking the lights terminals swapped over and back again and all's well. This shws the light is OK, but...
@Anaconda - actually, you were right! Your train of thought got me thinking, and I removed the spacer washers on the outer rear bolt, and it not all works fine :) . All it needed was to look at it with a fresh pair of eyes, so thanks very much much!
Honestly I don't think this one leaks at all! I know its practically unheard of with any Land Rover, never mind one that's almost 40!
There could be a small leak somewhere I haven't spotted yet, but I got way more on the ground trying to drain...
tbh, I'm amazed how anyone can buy a vehicle and know nothing about it. Missing front prop? Sounds like an utter bodge job tbh. If you knew all the issues before your purchased and how to fix them, then maybe it could represent a bargain. I truly...