I said that the connector is not there next to the other two as in the photo, but surely somewhere it will be.... so in your opinion, what would be the cause to solve the U codes problems ?

So, as far as the large earth cable I unplugged it to clean it, for other circled wire luckily it's not a broken cable but pine needles... instead regarding the 3 connectors, there are only 2 and they could be those but the one for the power supply to the compressor is missing, I'm attaching...

I checked the position of the front sensor connectors and the compressor power supply, but I found nothing under the front wheel arches, how is this possible? 2006 LHD ?

gstuart many thanks to you too, I will also do these checks hoping to reach a positive solution, the photo of the front height sensor connectors is excellent, but do you know where the C0377/C0391 connector for the rear sensors is ?

Yes, we jacked up the car, first from the front-left wheel, then rear-right one. height sensors reacted issuing a much higher voltage but the compressor did not start. I delete the error codes but they return immediately......

I know that bridging the relay is not the way to solve the suspension problems of a D3, I have read the suspension codes and the possible causes but then doesn't it seem strange to you that the 4 height sensors all broke together ? now the car stands on bump stops, so it is also problematic to...

Hi, I bridged the contact pins 30-87 and in fact the compressor started, so I thought the relay was faulty and I fitted a new genuine Land Rover LR126493 one, but the compressor stopped working I tested the jumper again and in fact I have 12V at the connector and the compressor starts, but when...

Thank you sierrafery ok they are pins 3 and 5 of the relay respectively, so if the compressor starts and I don't expect it to inflate the suspension, what else can I do ?

Hi all, 2006 D3 LHD with the same situation: compressor does not work does anyone know which relay pins need to be bridged in order to test the compressor ? thank you Giacomo

thank you, but unfortunately it is not the same, 1990 is different

replacement sender the same : PRC8823

Already tried but does not give the reading.... the right pins of the plug are these Giacomo

But how do I know which of the 2 black wires is that of the reserve light ? thank you Giacomo

Hi Mark and thank you for answer I still have to check the wiring.... Giacomo

Hi all, 1990 2.5 VM with the following problem: fuel reserve warning light always on regardless of the liters of fuel in the tank already replaced the fuel tank sender unit but the problem remained at this point all that remains is to replace the RTC6600 gauge fuel or is there some other...