I was dying to ask that 🤣

Not the clearest picture but you can see the step brackets in place here. The sill is still off so it’s easy to see. Hope that helps.

Brackets from a side step. Been cut off probably level with sill rather than bugger about trying to take em off.

And if ye rub it in yer nob the wife thinks she’s got marathon man….😎

Turners engineering would get you all the parts you need. I’ve used them a few times and the spares they sell are top notch. They sell full kits too.

Hmmm…my eyesights been affected by the TT thread 🤣

Maybe the governor playing up. Timing? I like the old mowers boss.

Oh I think you would do just fine with a 110 high capacity in the 300 tdi engine. I’ve used one for farm work…one of the guys on here has one for looking after his horses and stuff so he could probably keep you right with advice on them. Hi-cap phil. Hope you get sorted.

About wot?

Chow mane ones do fine 🥷

Here’s what I did to mine in case this helps you I hope. Sticky butyl with the hexagon pattern. 2.5mm. Off eBay from a vehicle company. Can’t remember the price but it was acceptable. I put it on the footwells, gearbox tunnel, under and in the seat box and around it, in the back the wheel wells...

It’s not a steering protector at all…it’s a hand rail for getting under it/ back out under it when those brutes break down 😎

Wot was being ignored again🤔

Great work..take your time and enjoy it. Can’t wait to see the finished Land Rover. 👍

No problem. He’s not made his mind up what engine is going in but if it’s the diesel then yeah I’ll message you. 👍