Sorry delayed coming back, I have been away and unable to get to the car until today. V1/V2 bolts don't appear to do anything. Engine warning light has now appeared (great!) which I think usually signifies EGR valve sticking. Taking to be plugged in tomorrow and will get them to show me how to...

Thanks for picture. I definitely saw at least one of the the V1 V2 bolt heads. It didn't appear to turn but I'll have another look tomorrow. Thanks again, oh and Happy new year!

Thanks, I'm 90% sure they are Halogens, certainly not turning xennons. Thanks for Onedrive manual, looked all through but afraid nothing helpful. I just can't see the so called adjustment screws and can't see any blanking plugs. I'm at a loss at the moment.

Not sure whether they are Halogens or bixenons, I guess Halogens because I presume they were the originals and I don't think they have been changed. Afraid I can't tell because I'm not sure what to look for. The main thing is, there are no sign of Phillips screws that they say to use to adjust.

Disco 3 2008 SE Deisel. Went in for MOT and they said dipped beam was too low so they adjusted it higher. Now miles too high! I suspect suspension was down a bit at the front when they did it - after service. In manual it seemed straight forward to readjust, I've done it before with other...

Sorry my reply crossed with yours. That's great should be able to get to it now.....thanks again

Thanks for your help. I found one bolt next to the rear seats by the back door. That loosened that area but can't find bolts by the boot door at the moment so if you were able to find more info would be grateful. Afraid I don't know what your comment on the seat belts refers to?

Guys, I recently sold my loved (and hated!) P38 after 12 years - and bought an 08 Disco 3. All ok at the moment except the Park distance control which just gives out a continuous bleep when I switch on ignition then doesn't work at all, with the warning light flashing. Plugged in (£20) by...

Sorry for delay replying. Car is an Auto. Have had one or two people say that the 13 pin is more complex than the old 7 pin or twin sockets. I have used a converter from 13 pin on caravan to the double sockets on the back of my old RR. I could do the same with the Disco if that was best...

Well, after 12 years have sold my loved and hated (but mostly loved) P38A. Now bought a Disco 3. I've left the Rangey forum and joined you lot in Disco. Hello! So, anybody any fitting instructions or advice on fitting 13 pin electrics to my shiny disco 3. Can't seem to find anything under...

Disco 1, 3 years. P38 12 years sold with regrets. Disco 3 from July 2017

I've towed with a (chipped) BMW diesel P38 Auto for 12 years. Quick it ain't, but it is happy to work hard pulling the van - but my van's nearer 1500kg so 1800 would be a bit harder I suppose. I've towed with lots of cars over the years including 4wd's - Jeep Cherokee (don't!), a Shogun...

Ref: your advice and comments chaps. In the first reply above from "Grrrr" - your possible diagnosis was correct mate. An airbag feed wire under the seat had become tangled in the seat runner and had shorted out. So have a look at yours! As "Grrrr" also said, there are lots of seats on...

Cheers for that - although I've no idea where the crash sensor or wiring might be? I had assumed it was built into the seat.......

Hey! Never thought about changing the seat! Doh! Thank for that I'll look on eBay now. Rob