Hello Sierraferry, I have been out to my disco today now that the storm has passed and I have done as you asked. When I select neutral all dash indications are as expected, the led lights up at the shifter and the N appears on the dash with pin one and two bridged. I have a spare XYZ switch that...

I will do, there's a bit of storm hitting us just now and it has been wild out there all day but as soon as this bad weather passes I will get back out to it. I will post a reply on here as soon as I can and thank you

I suspect the diagrams could be wrong as I believe that they have been wrong in the past. I will leave the wiring alone that goes to C0245 and just put the relay on a switch for the short term. I'm a full time carer for my 82 year old mum who has advanced dementia so finances are limited and...

Thank you for everything, I have the fire brigade on speed dial and a spare BCU to hand. It shouldn't burn too fiercely as it is torrential rain here right now 🤦‍♂️and thank you again 😊. I will double check everything as per your instructions when the weather eases up 😊

Yep, I've got that. When I bridge pins 1 and 2 at CO668 the reverse lamps come on. My understanding is that power goes to the XYZ via C0668 pin 1 when reverse is selected that power goes back through CO668 pin 2 and out to the BCU and the EAT where it is processed and fed back to the relevant...

I Have no voltage at pin 11. There are 7 outputs from the BCU CO660 that go to C0245. These outputs correspond to the relevant indicators on the dash and on the transmission selector. Do you know how to identify which one brings the "R" led on at the transmission lever

I do

I've tried another second-hand one but they tend to have the same faults. £700 odd for a new one is just out of reach for me right now 🥺

I have continuity between pin 11 on CO102 and the cluster. It looks really clean in there as well with no signs of corrosion. Connector C0668 at the handbrake has power on pin 1 but nothing on pin 2 with reverse selected. The wire that I'm looking for is the one that brings the red led indicator...

Thank you for replying. I have power going in to the switch but nothing coming out when in reverse. Rear wiper isn’t working either but I will check that out. On a side note do you know what wire the output for the reverse led comes out on

Hello folks, I've searched the diagrams and I can't for the life of me find what I'm looking for. I need to pick up a trigger for a relay to operate my reverse lights. There's a feed comes from the reverse led on the selector. If I could find out which wire it is I could tap into that My XYZ...

Thank you, I will source a modulator and ECU and see how I get on

What I have noticed is that it throws up a fault on the other 3 corners occasionally as well. I see on your post that there is a rewire that can be done using a single wire. Is this an option at this stage or is it an ecu and possibly a new modulator first

Thank you Sierraferry I will check it in the morning

Thank you Griff. I will check later on when the snow goes off