Hi thanks for your response a full rebuild all that you mentioned been done except the injectors not been refurbished thanks much appreciated

Hi just finished rebuild on my 200 tdi engine but still blue smoke when I rev it but not on idle can’t take it for a good run as it’s a rolling chassis any ideas much appreciated thanks

Hi yes a lt77 box and a disco 200tdi engine but the wading plug hole isn’t in line with the flywheel to lock it to set the timing on the pump would it be a different bell housing

Would the arrow on the housing be ok to set the timing on the pump

Flywheel bell housing hole for locking pin not in line with flywheel what next any ideas for locking flywheel at TDC Much appreciated thanks

Flywheel bell housing hole for locking pin not in line with flywheel what next any ideas for locking flywheel at TDC Much appreciated thanks

Which is the best crankshaft rear oil seal to use and is it fitted flush to the front or to the back thanks

Hi any ideas for cleaning debris out of a stripped down engine block

Hi thanks for your response I will have a look tomorrow on the piston walls but on the pistons crowns there’s number Tx err 1387 The crosshatching is still good the pistons ring were free and pretty clear but there were carbon marks on the side’s just around the conrod pins up to the rings not...

Hi just stripped down to the pistons out stage so what should I be looking for on the pistons and rings and how to find what size rings are on as no reference numbers and how far do I continue or I am at the point of no return thanks

Disco 200tdi camshaft Hi thanks for your response tried a bit of heat and plenty of wd40 and clean up the shaft and the laser puller still no joy

Hi yes the cam sprocket first and then crankshaft damper came off ok but it’s the crankshaft sprocket behind the damper which is the problem thanks much appreciated

Hi started stripping down to get to the cam everything was going fine until I got to the crankshaft spocket I used the puller which uses the 3 screw holes on the sprocket 2 hours later still the same any ideas much appreciated thanks

Hi thanks for your response would you mind if I asked you whereabouts you purchased your cam and followers etc it seems to be a good price thanks

Hi thanks for your responses so if I fitted a new cam would I need new cam bearings as well thanks