Thread 'Rear wheel arch repair panel' https://www.landyzone.co.uk/land-rover/rear-wheel-arch-repair-panel.376874/ Anything here?

Looked at paint man Good for the fronts, but don't seem to do 1 piece second row 🤷

Morning all. Just a quick one. The time has come to purchase a new set of doors for Noel, my 109 station wagon. Have found where to get the two piece front doors, but am struggling to find the one piece second row doors. The only supplier I found (below) is no longer stocking them 😕 Any...

And don't tighten body panels, bulkhead and side frames until everything is lined up and packed/shimmed. Don't ask me why I know 😭

Looks tidy. Keep everything as whole/complete as possible. Photos of everything. Bag and label everything. Allow triple you budget Allow ten times the time. Have fun Don't throw anything away!!

When I re chassis'ed Noel, I used a Richards chassis (👍👍👍) And replaced all bushes, engine and gearbox mounts , brake pipes, clips/brackets etc with new.

Had to adjust just about every single item. Never, ever fit anything tight. Roof, side frames, tubs, wings bulkheads etc before checking everything lines up. We live and learn 🤔🙄

You can, but from bitter experience, I wouldn't recommend it 😭

I had another look, it's totally my fault. They do with or without mesh. I thought that meant the actual mesh screen. What it actually means is recessed for mesh, or not recessed for mesh. Looks like if I cut of the tabs I can custom fit it 🤔🙄

Bugger. I think I see what I did wrong. I obviously forgot to choose the mesh version 🤯 So, can I just fit it flat?

Afternoon campers. Today I decided to refit the upper dash on my S3, just to make sure everything lines up before recovering with new vinyl. First job, fit the fly mesh to the bulkhead. Only it doesn't fit 🤯 This is how it looked in the old bulkhead As you can see, the inside of the...

Keep the faith, half of the tyre is still inflated 🤪👍

Thank you, I'll have a good look 👍

Yes, but the bit I need is not on that page and I don't know the actual part number of the bit I need 🤯 It's this bit