What an absolute pain! So much complex and buggered by a terminal.clamp 🤣 I used this on my 110 shuttle valve. 10k later and still spot on...

Niice!!!!

They arnt difficult to remove, just requires the right technique. Use the correct filter from a quality brand. Smaller filter, needs changing more regularly. I change my oil and both filters every 6k.

A cage is a always a welcome addition to a land rover, ive had the misfortune of being in a severe accident where the cage genuinely saved my life. Not only that but its been a huge benefit for loading things on the roof! Saftey Devices also sell excellent brackets that bolt round the cage...

MOT Yesterday Passed! No advisories 😃😃

100% agree + Gareth would do a full health check before hand to check all is well. As with anything remapping can highlight any issues with the engine you currently have.

Id give Gareth and Empire Tuning a ring, he can give you the best information for what you want.

100% that. I was pleasantly suprised when my D44 bumper came and it was exactly as it was when I boughy my old one. Excellent quality

Appreciate the input but I assume youre fairly new to the forum and my threads 😅 Ive had a my fair share of Allisport some is ok some is very good. Personally been through 4 intercoolers, 1 header tank and 2 top hoses and a currently a manifold warping (that ill sort myself). All replaced under...

Yeah changed that fairly recently! Haha eventually not just yet though, still recovering from the house and subaru purchase 🙈🙈

Never ends does it! Finally been enjoying the 110 again, parked up and my mate said "whats all that red stuff coming out the bottom" FFS 😡 Not another coolant leak!! Quick check and the expansion cap was loose and had become soft and flexible? 🤷‍♂️ never experienced that before! So soft...

Well that is the last of the ABS saga at least for a while! New CV & Shaft. Lights came back... 🤷‍♂️ New sensor in lights gone! Funny how the sensor lasted a year to the day! But its a 2 year warranty so will be going back to Island4x4 for a refund.. Not the greatest photograph but had a...

Yup normal. Took the balancer off the front, got some flat bar, rotated the crank till 2 of the bolts where vertical (had to turn the steering full left), marked the bar, drilled 2 holes. Made a cut out for the crank bolt. Bolted the bar onto the crank, with the holes vertical its wedged...

Changed the ABS shuttle valve today. Absolutely hate doing this job, wouldnt be so bad if it was easyto get my wings off 🙈 Through the hole it is! Took about 3 hours and some cut wrists Finally out and replaced with a pre modified one which completely eliminates and future shuttle valve...

When changing pads i have never had an issue after. Sensor height is set by an air gap. So push it in as far as it goes, spin the wheel and thats that. Bleeding can done as you would a normal car, or you can use powerbleed function on nanocom which is amazing. Just crack the nipple push a...