For anyone trying to find out the answer to the immobilizer question, the TDCi 2.2 uses MEMS. The problem I was left with was not the alarm but synchronising all the buses between the ECUs. I had only been focused on the alarm adjustments and...
Top up/fill up…
Engine oil
Water
Screen wash
Kicked tyres
Power steering( looks like a small weep on drop arm)
A fixed a bit of tape to the throttle adjuster to stop the cable winding loose due to diesel vibrations
Loaded motor for few days...
That is always a possibility with any used vehicle I guess.
Owning a Defender is a battle of wills and usually it wins resulting in selling it.
As you go along you will come to accept what needs sorting and what needs monitoring. General...
This channel has useful videos to watch.
So does this one, although I have just picked random video as I don't know how to link a channel. Just choose some videos for info when a problem appears or for general knowledge.
The transfer box is a separate unit bolted on the back of the gearbox, the front and rear propshafts are bolted on to the transfer box. They both use a different oil, the main gearbox should be a thin red oil, the transfer box should be a light...
Lift the seat and have a look. I believe its possible on some models.
Not possible on mine as have a box under both seats. Besides I like to struggle and have the smell of EP90/ATF running down my arms 🤔 :p.
J
You can take the solenoid off, take the little plunger out, put the solenoid back in and effectively you will have an open flow of fuel.
Although my advise would be to change it if it's suspect as it is fiddly to change, involving grinding bits...
The small pipe is fuel leak off pipe to the pump.
I sent you a pm but basically you need to check for fuel going to lift pump, going to filter, going to injection pump.
It needs continuous 12v at stop solenoid to let fuel through.
When you are...
That's better, they do actually run quite hot. When I was looking into it a while back and I came across someone else's forum post with a similar issue.
He booked it in at a specialist who suggested mid 90s is correct for a 200tdi. Pretty sure my...
Broken wire. Hence lights didn’t clear on new bearing he then swapped the wire so air gap to large. Have Re wired and replaced bearing and sesnor now sorted.
Yes, there is a wire going to the back of the injection pump, looks like it's a white one in your picture. If you haven't got 12v to there it won't let fuel through, crank but not start.