Are both head lights not on the same fuse??? I have to admit I didn’t look as I presumed that they would be in the same fuse.

My harness is connected just like that attached. Given that I don't have any instructions as I purchased the spot lights 2nd hand from e-bay the only wire that remains is that of the High Beam. Where does that go? As I mentioned previously i connected it to the high beam wire just prior to the...

There is a 30 amp fuse between battery and relay. The yellow wire connected to the headlight H'beam feed is a trigger wire that operates the relay once it senses power. It is labelled 'To Negative/H'Beam switch'. I'd imagine this is the wire causing all the problems but apart from to negative...

Do both headlights not share the same earth? Also given that the headlights worked perfectly prior to connecting the spotlights and the wiring harness, would tell me that the earth is not the issue but more so whatever I have messed with during the install.

They have a switch that needs to be activated before they will operate with the flasher/high beam.

Nope. They are 100W Halogen Lightforce Striker 170s. But they are on their own circuit.

So the multimeter tells me that on high beam there is no power getting to the connector to the nearside headlight???? Head scratching time. Also for info I have spliced the yellow wire in the images shown above to the H'beam feed roughly 2" short to the offside headlight connector. (Might be...

Yes

My headlights are Halo LED units. There are no bulbs to replace.

Right, I have connected all the wires. Now I have other problems.... when I put my lights on high beam my spotlights operate along with my offside headlight but my nearside head light goes out. When I switch off the high beam the nearside light comes back on. Any ideas???

It’s a 300TDI CSW 1994. The below photo is the only wire not yet connected. I want the spotlights to come on with high beam. 👍

I have fitted my spotlights to the front of the Landy. I have completed most of the wiring less one wire….it is labelled Negative/H’Beam. Where should it go??? I’m presuming that if I simply wish to trigger the spotlights via a switch then it goes to earth??? If I wish to trigger the...

I have seen flanged drive shafts for later models but not seen anything for the 300TDI. I have a salisbury rear diff and looking to replace the drive shafts both front and rear. These seem a nice upgrade and reduce transmission shock/noise. However, not sure if they are even available for the...

What modifications if any would be required to run this size wheel and tyre package? Is a lift kit required? What about wheel spacers? What size wheels and tyres do you think these are? Many thanks.

Recently had my brake servo replaced and i have been informed this evening that i have no brake lights working. Could the two be connected? If so where is the connection i need to find? (Vehicle is a 110 300tdi).