My harness is connected just like that attached. Given that I don't have any instructions as I purchased the spot lights 2nd hand from e-bay the only wire that remains is that of the High Beam. Where does that go?
As I mentioned previously i...
There is a 30 amp fuse between battery and relay. The yellow wire connected to the headlight H'beam feed is a trigger wire that operates the relay once it senses power. It is labelled 'To Negative/H'Beam switch'. I'd imagine this is the wire...
Do both headlights not share the same earth? Also given that the headlights worked perfectly prior to connecting the spotlights and the wiring harness, would tell me that the earth is not the issue but more so whatever I have messed with during...
So the multimeter tells me that on high beam there is no power getting to the connector to the nearside headlight????
Head scratching time.
Also for info I have spliced the yellow wire in the images shown above to the H'beam feed roughly 2"...
Right, I have connected all the wires. Now I have other problems.... when I put my lights on high beam my spotlights operate along with my offside headlight but my nearside head light goes out. When I switch off the high beam the nearside light...
I have fitted my spotlights to the front of the Landy. I have completed most of the wiring less one wire….it is labelled Negative/H’Beam.
Where should it go??? I’m presuming that if I simply wish to trigger the spotlights via a switch then it...
I have seen flanged drive shafts for later models but not seen anything for the 300TDI. I have a salisbury rear diff and looking to replace the drive shafts both front and rear. These seem a nice upgrade and reduce transmission shock/noise...