tom1979

tom1979

Well-Known Member
Full Member
i bought a set of Wurth manifold bolts a month or so ago and finally got around to doing it after getting the manifold skimmed.

The came with copper lock nuts and I found when fitting that all of the ends of the threads were stripped a bit by the copper nuts. One stripped the threads before it had even got to 25nm and then the stud snapped when it was undone.

I have read everywhere how great these studs are so is it likely I've just bought some cheap Chinese s**t that's being sold as Wurth?

IMG_7099.JPG APC_0963.jpg
 
Dippypud said:
If they were sold to you as Wurth, then you should care a bit ....
Click to expand...

I wasn't saying I didn't care, just that I've ordered some more that are coming in a Wurth box as I need them now. I can deal with the broken ones later in the week. If they want me to send them in I can.
 
Bit of a concern! I ordered some a good while back, only fitted on stud tho as why tempt fate by trying remove non-snapped ones! Haha. I did however use all the copper nuts

Fitting was fine for me and quality looked good. Though ill double check.

Out of interest where did you buy both sets from?
 
Both from eBay! I think the first ones definitely aren't right I'll ask wurth what they reckon
 
You must log in or register to reply here.

Similar threads

Captain Cavemen
Series 3 petrol 2.25 head gasket
Replies
14
Views
717
Captain Cavemen
Captain Cavemen
rover75lover
L322 injector problems/tips
Replies
3
Views
318
Pug957
P
S
Panhard rod
Replies
7
Views
1K
Hicap phill
H
H
TD5 head replacement issue, tap noises
Replies
0
Views
1K
harrym8
H
A
P38A Coolant in cylinder head inlet passage
Replies
5
Views
2K
Eldon
E