P

pauls440

New Member

• Sep 4, 2011

• #1

Hi all yet another question
I think i need new uj's and maybe all the bits on the front as I'm getting a vibration and a noise like a worn bearing ,
so I'm thinking start with the uj's and going from there.
i have a 2" lift and i think this was the start off the problem , iv ordered a new set off standard springs to replace,
and wares the best place to get them from

any help would be appreciated

 

Last edited: Sep 4, 2011

The Mad Hat Man

Well-Known Member

LZIR Despatch Agent

• Sep 4, 2011

• #2

yu wanna sell yo rear springs?

 

P

pauls440

New Member

• Sep 4, 2011

• #3

sorry but i think my brother wonts them

 

C

cuza68

New Member

• Sep 4, 2011

• #4

if you are having a noise from the front end and are thinking of changing the wheel bearing then you might aswell change the cv joint aswell. saves time

 

bigrichsri

Active Member

• Sep 5, 2011

• #5

pauls440 said:

Hi all yet another question
I think i need new uj's and maybe all the bits on the front as I'm getting a vibration and a noise like a worn bearing ,
so I'm thinking start with the uj's and going from there.
i have a 2" lift and i think this was the start off the problem , iv ordered a new set off standard springs to replace,
and wares the best place to get them from

any help would be appreciated

Click to expand...

If you've got a noise that sounds like a worn bearing, I'd start by looking for a worn bearing

 

nrgserv

Well-Known Member

• Sep 5, 2011

• #6

check fron prop uj's. then gearbox output flange to front prop.

 

P

pauls440

New Member

• Sep 5, 2011

• #7

ok is there any one near me that could have a lisson to the hoise to see what they think

 

Mr Noisy

Coming in your ears.

• Sep 5, 2011

• #8

front prop most likely

give it a good wiggle to see where the movement is, as it could also be transfer output bearing as stated above.

my advice is find the problem yourself and then you does become educated.