tyclyd

tyclyd

Active Member
Hi,

I have 3 nipples (one on the rear UJ and 2 on the drive shaft) that I cannot clear with a pin and i cannot get any grease into so I am going to swap them for new for my 2004 Defender - does anyone know what thread size they would be from the catalogue?

Thanks - Gary
 

Attachments

  • Nipple Sizes.JPG
    Nipple Sizes.JPG
    104.3 KB · Views: 9,930
tyclyd said:
OK - misread to be 6mm long - so if i am right that's an M6 screw in then?
Click to expand...

I read it the way you did mate. If he had said M6 instead of "6mm" his sarcy comment might have been justified.

And the part number your looking for is TYL100030.
 
Last edited:
meego said:
I read it the way you did mate. If he had said M6 instead of "6mm" his sarcy comment might have been justified.
Click to expand...
it wasnt a sarky comment **** if you knew the answer you should have put it better than i did ,i try and help more than some and i aint taking **** for it
 
You were being helpful in post #3 James. Then you spoiled it in #5. I read it as sarcasm. The OP was obviously confused between 6mm long and an M6 thread. Why did you not just explain that.

No point in name calling either mate. But if that's the way you are, fair do's.
 
im not perfect,just dont throw assumptions around ,i dont just stick to one thread but lots,theres plenty tell you to just do a search
 
meego said:
I read it the way you did mate. If he had said M6 instead of "6mm" his sarcy comment might have been justified.

And the part number your looking for is TYL100030.
Click to expand...

Can't see why you thought the comment was sarcastic meself :rolleyes:
 
jamesmartin said:
im not perfect,just dont throw assumptions around ,i dont just stick to one thread but lots,theres plenty tell you to just do a search
Click to expand...

Ok........I have seen a lot of your posts. You are helpful and LR savy. A lot more than some. But I still think it was sarcy. If I am honest, I did not really expect that sort of thing from you, as you usually try to be helpful. If I am wrong, then I apologise.
 
sarky , no i wasnt but i have a fair bit of criticism,spelling grammar,jealousy ,noses out of joint ,its harder trying to help than been a ****
 
You must log in or register to reply here.

Similar threads

F
Discovery 2 grease UJ
Replies
2
Views
598
NPG
NPG
S
Axles and Wheels - Which Type?
Replies
12
Views
879
Hicap phill
H
Lej
Land rover discovery 2 front prop shaft - can't find correct size
Replies
5
Views
1K
tilly2
tilly2
I
Puma prop failed.
Replies
7
Views
595
ItsMick
I
Mark Piercy
P38A Zf4 hp24 input shaft!!
Replies
11
Views
871
Datatek
Datatek