Scrawf

Member

• Mar 7, 2014

• #1

Did a search but can't find an answer.

I replace my P gasket today. All went well but I want to know what the torque settings should be on the three bolts that go through the gasket to the block.

The Haynes manual only give you settings for the water pump bolts but I wondered if the thee bolts into the block should be a bit tighter as they are going into the block?

Any help appreciated!

Scrawf

 

L

lynall

Well-Known Member

Full Member

• Mar 7, 2014

• #2

Use your common sense, these are the last bolts you want to snap!

 

Kwakerman

Well-Known Member

• Mar 7, 2014

• #3

25Nm (18 lbf ft), I always use new bolts - saves any hassle next time.

 

Last edited: Mar 7, 2014

Scrawf

Member

• Mar 8, 2014

• #4

Thanks fellas. Yeah I realise there is a possibility of snapping them hence the request for torque settings! I did them up to 25Nm so looks like I have done it correctly. I figured that the top ones screw into the alloy casing behind the water pump so they didn't want to be too tight but the bottom three are into a steel head block so could be a little tighter as they are the ones that compress the P gasket.

Anyway let's see if she leaks today after a good run out!

Scrawf

 

Scrawf

Member

• Mar 8, 2014

• #5

kwakerman would you please tell me which manual you have there and where I can get a copy? Looks much more detailed than my Haynes manual!

Thanks

Scrawf

 

Kwakerman

Well-Known Member

• Mar 8, 2014

• #6

Scrawf said:

kwakerman would you please tell me which manual you have there and where I can get a copy? Looks much more detailed than my Haynes manual!

Thanks

Scrawf

Click to expand...

PM me with an email address

 

Scrawf

Member

• Mar 9, 2014

• #7

PM sent. Thanks fella!

Scrawf