pete12345 · Jul 18, 2020

are the tf126 model to long for my vehicle still on air bags 1999/2000 Thor

Datatek · Jul 18, 2020

pete12345 said:
are the tf126 model to long for my vehicle still on air bags 1999/2000 Thor

I do not know, but for road use OEM shocks are best, fronts are longer than rears.

pete12345 · Jul 18, 2020

I've already got a set of terrafirmas for rear just struggling to get bottom nuts on with there bush in place

pete12345 · Jul 18, 2020

Trying to rember who fitted a set recently I did see a post on it

Datatek · Jul 18, 2020

pete12345 said:
I've already got a set of terrafirmas for rear just struggling to get bottom nuts on with there bush in place

Make sure they are the right length or you could end up bursting an airbag

pete12345 · Jul 18, 2020

Yer will do thanks

pete12345 · Jul 18, 2020

I think 300bhp/ put them on his vehicle a while back

300bhp/ton · Jul 18, 2020

I put the rears on mine. I trimmed the lower bush. The shaft sticking through the mount is not long enough. No idea how they were meant to fit.

The shocks are a lot longer than stock. Lot more down travel available. About to fit extended brake lines and the ABS sensor lead needs more slack.

pete12345 · Jul 18, 2020

Henry b gave me the solution just leave off bottom cups

Henry_b · Jul 18, 2020

The cups on the axle are there to house the rubbers..

the 2 extra TF ones aren't needed

RangeRoller dt · Jul 19, 2020

Don’t fit the bottom 2.

The non +2” TF shocks are same with the cups.

pete12345 · Jul 19, 2020

Mine are tf126 not ment to have +2 but there still not going in with the cups

brianp38dse · Jul 19, 2020

Have you tried jacking the axle up putting a bit of weight on them, which will push then down in to the top cup.

Mark Piercy · Jul 19, 2020

brianp38dse said:
Have you tried jacking the axle up putting a bit of weight on them, which will push then down in to the top cup.

The shocks will rise aswell.....

brianp38dse · Jul 19, 2020

Mark Piercy said:
The shocks will rise aswell.....

Not if you bottom them out

pete12345 · Jul 19, 2020

Yer all sorted now only one balls up had to change 1 bolt on back of radius arm was in wrong way

Mark Piercy · Jul 19, 2020

brianp38dse said:
Not if you bottom them out

Oh yeh...

pete12345

Well-Known Member

Datatek

Well-Known Member

pete12345

Well-Known Member

pete12345

Well-Known Member

Datatek

Well-Known Member

pete12345

Well-Known Member

pete12345

Well-Known Member

300bhp/ton

Well-Known Member

pete12345

Well-Known Member

Henry_b

Think outside, no box required.

RangeRoller dt

Well-Sprung Member

pete12345

Well-Known Member

brianp38dse

Well-Known Member

Mark Piercy

Well fumbled member....

brianp38dse

Well-Known Member

pete12345

Well-Known Member

Mark Piercy

Well fumbled member....

Similar threads