Is there any way to get my indicators to work temporarily? My hazard switch fell to pieces when I was trying to track down why my alarm keeps blowing its fuse.

Looks like it is because the hazard switch has fallen apart and I think its shorting the indicator fuse and the alarm fuse when the alarm tries to go off, or when it tries to 'blink' when you arm it.

Is there any way I can hook up the two spade connectors to get the indicators to work for a couple days until the new switch arrives?

I did a bit of hunting round for a diagram, according the one i found it shows the hazard switch as a multi pole switch, not sure if this will work but it looks as if the purple and two green wires are joined when the hazard switch is off.

You could try this but i personally would wait tills the switch arrives, just a quick tip if your not sure whats blowing the fuse, break down the circuits into individual circuits using inline fuse holders. So say for example if you 4 circuits running off one fuse, put fuses in all circuits and then when one blows you have your culprit.

Lee