woods767

Well-Known Member

• Mar 4, 2011

• #1

Hi,

My 110 has britpart yellow +2 springs, highest stiffness springs, and a +2 spacer under it which im not overly keen on eather.

Is there a spring that will lift my heavy 110 +4" with the spring only? Idealy i want a realy realy tall spring that not too stiff. I dont like the way my shock has to go through the spacer eather, its just a bit of a night mare set up at the moment.

I was also wondering if the 90 Disco and RRC have the same diamiter spring on the front and back, perhaps theres a 90 rear spring that i can put on the front???

Cheers, Rich.

 

woods767

Well-Known Member

• Mar 4, 2011

• #2

LAND ROVER DEFENDER 90 REAR SPRINGS +2" LIFT on eBay (end time 05-Mar-11 14:03:51 GMT)

For example....

 

jamesmartin

Well-Known Member

• Mar 4, 2011

• #3

rear springs ten to be taller as angle of front axle,rears from rr ,90 or disco will fit 110 front

 

woods767

Well-Known Member

• Mar 4, 2011

• #4

Do you think I would get a 3-4" lift off those rear 90 springs??? It would be a good solution if so.

 

tottot

Well-Known Member

• Mar 5, 2011

• #5

woods767 said:

Do you think I would get a 3-4" lift off those rear 90 springs??? It would be a good solution if so.

Click to expand...

No it will not,bet your landy has a very stiff ride with the set up.you have got.

 

woods767

Well-Known Member

• Mar 5, 2011

• #6

Its got 230 lbs/inch on the front and 400 lbs/inch on the back, the front is fine but the back is very hard when unloaded. When loaded the fronts a little squidgey and the back is perfect.

 

woods767

Well-Known Member

• Mar 22, 2011

• #7

Sorry to drag this up again, but my MOT is booked for friday and I need to sort this out!

I need my 110 to sit at about +3" to +4" high at the front when unloaded, using only a coil spring so my silly 35" tyres dont have their way with the bodywork. Im currently tempted to fit these:

DA4204 Britpart HD Yellow Coil Springs (pair) - Rear 300-340lbs/inch

Anyone know how high the front might sit with them?

Thanks, Rich.

 

jamesmartin

Well-Known Member

• Mar 22, 2011

• #8

like the yellow springs but dont know how much it would sit down but as a rule of thumb fronts an inch shorter than rear but front is heavier

 

woods767

Well-Known Member

• Mar 25, 2011

• #9

Ive got a pair of bearmach rear springs (+40mm 295 lbs/inch) for it now, need some new ES9000s though befor I fit them, my old ones are preaty mashed up. Will be interesting to see the result.

 

Boris113

Well-Known Member

• Mar 25, 2011

• #10

Might be a tad late now but I think bearmach do a 3 inch spring?

Failing that scrapiron racing/extreme 4x4 make custom height springs.

Why are you worried about spring spacers for the MOT? If fitted correctly and safely they will pass

 

woods767

Well-Known Member

• Mar 25, 2011

• #11

Its a horrible spacer that just lifts the spring seat, the shock goes through the spacer and onto the axle. It doesent realy work properly and the shock fouls on the spacer pice, ive been meaning to get rid of it for a while.