E

Earlofdon76

Member

• Tuesday at 23:59

• #1

Hi folks,
Finally got my hands on an icarsoft CR Pro and scanned the TD6.
I’ve got a fault code on the SAS stating CAN message error.

Anybody know what it means exactly?

Also, a flame out fault on the FBH.

Any information gratefully received as always.

TIA.

 

backinblack

Well-Known Member

Full Member

• Yesterday at 10:01

• #2

Do they come back if you clear them?

 

Mark Piercy

Well fumbled member....

Full Member

• Yesterday at 11:10

• #3

Can bus error is when communication between the steering sensor and it's counter part aren't talking or haven't in the past. Is code active /sporadic or history?
Check on live data while turning the wheel and check the sensors readings in degrees and look for jumps or glitches in the value from left to right at a slow pace

 

K

kds

Well-Known Member

• Yesterday at 23:52

• #4

Didn't the poster have a problem with ABS kicking in?

 

E

Earlofdon76

Member

• Today at 02:05

• #5

Yes bud.
I’ve cleared the fault code which showed up in the SAS, ABS, and air suspension modules.
ABS lights came on but went off after a restart. Air suspension went up, down and then back to normal.

Fingers crossed .

Many thanks for all of the advice folks. Very much appreciated.