W whitto999 Member Dec 18, 2013 #1 After my cam belt snapped which broke a few rockers bent most of the lifters any way I replaced all bits and sorted the belt out now the beast won't start just turns over, please help
After my cam belt snapped which broke a few rockers bent most of the lifters any way I replaced all bits and sorted the belt out now the beast won't start just turns over, please help
Rangey185 Active Member Dec 18, 2013 #2 Have you checked the connections going into the starter motor? Tied jump starting? Any noises when it turns over? Clicks or anything or just nothing?
Have you checked the connections going into the starter motor? Tied jump starting? Any noises when it turns over? Clicks or anything or just nothing?
tetsu0san Active Member Dec 18, 2013 #3 When you put it all back together it is possible to get the crank 180 degrees out. Are you sure you have it all the right way round?
When you put it all back together it is possible to get the crank 180 degrees out. Are you sure you have it all the right way round?
W whitto999 Member Dec 18, 2013 #5 Set the crank using DTC on the fly wheel, but I had adjust the fuel pump as I couldn't lock it out.
W whitto999 Member Dec 22, 2013 #6 Finally got my Disco running after a lot of head scratching and tea drinking thanks for the advice everyone much appreciated.
Finally got my Disco running after a lot of head scratching and tea drinking thanks for the advice everyone much appreciated.
