noiseboymart

noiseboymart

Active Member
Probably a daft question but does anyone know where to get single hex 27 mm ring spanners from.I can find no end of bi- hex spanners but not one single hex on the web or local places.
Cheers in advance
 
I want to remove upper a frame arms from chassis brackets and the bolts are pretty rusted up so a hex spanner is less likely to round them off than a bihex and it should give me better purchase on the nuts
 
just use a std spanner and socket i manage with a 1 1/16 spanner, if its too tight you can always split nut with a chisel
 
I used stillsons and a spanner until it would not budge. Grinder was only answer. Get new bolts before you start. For some reason a 28mm spanner worked for me? Dunno if the bolts were aftermarket
 
noiseboymart said:
I want to remove upper a frame arms from chassis brackets and the bolts are pretty rusted up so a hex spanner is less likely to round them off than a bihex and it should give me better purchase on the nuts
Click to expand...
When I had to remove those nuts on my vehicle, I used lots of Silkopen, a blowtorch, and a 27mm socket.
 
If they're giving you difficulties, it's a lot easier to take the brackets off the chassis as they're only held on with three 10mm bolts each side. Once they're off you can do whatever you like to the recalcitrant nuts and bolts on the ground or in the workshop.
 
"If they're giving you difficulties, it's a lot easier to take the brackets off the chassis as they're only held on with three 10mm bolts each side. Once they're off you can do whatever you like to the recalcitrant nuts and bolts on the ground or in the workshop."

yeah remove the brackets with a rotary spanner...they were not coming off with sockets - even hex or irwin bolt grips.

i found the big 24s easier to work with. - 24mm hex socket on a 3ft breaker bar and a bi hex 24 on the otherside and just raxed it up.
 
Well, the way I see it, if a nut and bolt won't come undone with a reasonable amount of force it's time to replace it anyway, so you night as well grind it, drill it, chisel it etc. because you're improving things for the future.
 
You must log in or register to reply here.

Similar threads

Skiddy 1
Freelander 1 handbrake switch.
Replies
2
Views
293
Skiddy 1
Skiddy 1
Stanleysteamer
Dixon-Bate.
Replies
5
Views
1K
Stanleysteamer
Stanleysteamer
A
P38A Interior Map/ Courtesy Light Wiring
Replies
1
Views
335
Mark Piercy
Mark Piercy
rover75lover
L322 injector problems/tips
Replies
3
Views
309
Pug957
P
C
2.2 puma Defender exhaust
Replies
2
Views
157
Wimblowdriver
Wimblowdriver