Landie_Man
New Member
Not really worth it in this country, but out of interest, where would you moung a snow plough too on a series, with minimal modification?
j the range
New Member
yes defo i would put it on the front
Dewin
Well-Known Member
tacr2man
Well-Known Member
Having done so on discovery and 110 , and some other bigger vehicles
The usual is the carrier frame mounts to the front end of the chassis rails with landrover products utilising the front bumper mounts the lower end of the carrier frame then has bracing bars that run back under the front axle to a bracket attatched to chassis in area of gearbox crossmember .
You will need to fit heavy duty springs , and in some cases ballast the rear of the body . The lightweight poly plows are the only really viable ones on landies , the others are really too heavy HTSH
The usual is the carrier frame mounts to the front end of the chassis rails with landrover products utilising the front bumper mounts the lower end of the carrier frame then has bracing bars that run back under the front axle to a bracket attatched to chassis in area of gearbox crossmember .
You will need to fit heavy duty springs , and in some cases ballast the rear of the body . The lightweight poly plows are the only really viable ones on landies , the others are really too heavy HTSH
