Got this pretty display the other day - what's that about?



Plugged in my Nanocom but no stored faults. Would this be a fault in the SLABS unit itself? It's not reappeared since, but I have seen it before some time ago. Any ideas welcome!

If no codes are stored it could have been a momentary loss of power feed to the SLABS ECU or an ECU misbehaviour

sierrafery said:

If no codes are stored it could have been a momentary loss of power feed to the SLABS ECU or an ECU misbehaviour

Click to expand...

That's a thought.... It happened when I braked for a junction I think, and I've had three amigos a fair bit recently when stopping at (weirdly) the same two junctions on my way to or from work. So could be a bad or loose connection somewhere, but it's not like I'm slamming the anchors on at the junction!
I'll take the side panel off and have a wiggle of the loom, see if I can set it off again.