C

chrisarb

New Member

• Apr 28, 2011

• #1

which way do I push out rear hub bearing. help disco 1 1995

 

jamesmartin

Well-Known Member

• Apr 28, 2011

• #2

there two brgs in there one comes out front one out rear .the same brg rtc3429 both sides do not punch brg outer race into hub use a dolly or old brg race as tool to put back in direct hitting with punch will **** brg race ,not noticeably but you push and turn brg in race and youll feel the damage

 

C

chrisarb

New Member

• Apr 29, 2011

• #3

ok thanks now done. next problem can not get half shaft back in. days ago I did make near fatal error by slightly turning igniton for micro secon d. vehicle jolted slightly as back end on axle stands. does this mean I will have to turn opposite wheel to fit half shaft?

 

jamesmartin

Well-Known Member

• Apr 29, 2011

• #4

no twist it ,it will line up

 

M

MrPDude

Active Member

• Apr 29, 2011

• #5

Twist half shaft until splines line up. then turn wheel till hub bolts line up