B

blgdave

Active Member

• Sep 16, 2014

• #1

Hi Folks,

Looking to order up some new gaskets for my D2 roof rails and notice that there are upper and lower gaskets listed for each of the four corners.

Do I need to order two for each bolt as I just see the square gasket from the outside?

Where do the cut away shaped upper gaskets go??

Cheers

Dave...

 

listerdiesel

Well-Known Member

Events Planner

• Sep 16, 2014

• #2

AFAIK there is a sponge gasket only between the rail and the roof, because the rail foot bolts through the roof to an inner mounting.

Adhesive sponge gasket is CAJ100320.

Peter

 

B

blgdave

Active Member

• Sep 16, 2014

• #3

Cheers Peter.

Have you any idea what this part is for the same corner then?? CAJ100350

They list an upper and lower gasket which confuses me?

I will just remove my rails and have a look now I know I can get them. Would be good to know why they list two though??

Cheers

 

B

blgdave

Active Member

• Sep 16, 2014

• #4

I got that number mixed up. For reference...

Roof Rail Gasket - Rear Lower RH - Genuine Land Rover Part No.: CAJ100320

Roof Rail Gasket - Rear Upper RH - Genuine Land Rover Part No.: CAJ100340

 

listerdiesel

Well-Known Member

Events Planner

• Sep 16, 2014

• #5

Mine is a very early one, 1998 build so may not be representative.

I'll have a look on Microcat when I get a minute.

Peter

 

auf_wiedersehen_pet

Well-Known Member

• Sep 16, 2014

• #6

I bought a set of gaskets from Craddocks after my respray. Spent a fortune and ages trying to get them to deliver the correct ones and ended up returning the lot when I bought G4 bars. When I get round to it, I'll make my own for a fraction of the cost with 6mm adhesive backed neoprene.

£3 or £30 - your call?

 

B

blgdave

Active Member

• Sep 16, 2014

• #7

Now I have stopped looking at that giff...

They are listed as only 2 pound each with Rimmers, but the squae ones do look very simple. It was just the cut out shapes of the upper ones that have me confused?

I will remove the bars tonight and have a look. I held off ordering last night anyway.

Mine is a 2001 model if that shows on the Microcat by the way?

Cheers

 

B

blgdave

Active Member

• Sep 17, 2014

• #8

Sorted, there are two gaskets per corner. Each foot of the bars is made up of two gaskets stuck together...


2 quid each, but look real easy to make?