Hello,

Just a quickie, I have used my nanocom in the past to calibrate and set the normal ride height. with the following results.

RH sensor output = 148 / height ctr wheel to wheel arch = 480mm

LH sensor output = 147 / height ctr wheel to wheel arch = 477 mm

which I can live with as they are near enough to the 473mm spec and within the +- 15mm tolerance.

When I press off road mode, I get the following.


RH sensor output = 177 / height ctr wheel to wheel arch = 531mm

LH sensor output = 174 / height ctr wheel to wheel arch = 508 mm

So it appears that as they travel over their working stroke the sensors are giving a larger delta of feedback to actual measurement.

Now as a short term , I could swap then over and see if it I can swap the issue from one side to the other.

But can a nanocom also set the off road mode sensor target height and subsequently the actual height?

Cheers