Is it the EAS driver pack causing this new issue?


Symptoms: No leaks in system, Eas seems kinda working fine but after going above the 50 mile mark lowering to cruise hight it raises to wading height when stopping - goes to normal height when setting of again.


Also when compressor runs front seems to go up a bit too high and fall back to normal when compressor stops.


Around town stopping at light with foot on brake front raises with compressor running, hand brake on letting go of brake pedal it goes down to normal.

Checked connector LH foot well, cleaned without it needed it, was dry and clean already.

Check the heights are correct first, then clean all the connectors in the EAS box.
Both times when mine has behaved like that it's been a front height sensor playing up, so checking/cleaning those connectors might also help.

Datatek said:

Check the heights are correct first, then clean all the connectors in the EAS box.
Both times when mine has behaved like that it's been a front height sensor playing up, so checking/cleaning those connectors might also help.

Click to expand...

Thanks, will look into that

Cleaned all 4 hight sensor connections - Problem Solved


Thanks Data