A

alibream

New Member
Hi folks, am halfway through getting my 200tdi engine back together after the outer crank pulley came loose and destroyed my front woodruff key. I have got the cambelt off, repaired the crank and i am about to get the new crank pulley and cambelt back on (when the parts finally arrive) Anyway i was checking all of the pulleys etc were as left...and the injection pump seems to have moved a few teeth but i cannot get it back into position, in hindsight is sounds like i should have pinned it in place but i need to get it back to its old position to ensure that it runs nicely. Should it just turn back by hand? Do i need to rotate itclockwie back to the correct position? any help would be greatly appreciated, cheers
 
so get the crank and cam to the original position? if so they are there now, but need to adjust the pump pulley. Am guessing i could use the belt to move it back?
 
Theres loads of adjustment in the slotted adjustment holes son the pulley, move it back a tooth then loosen the three bolts and retime it.


Lynall
 
thats what i am struggling with, i have turned the pulley to as close to the original position as possible, then it just spins past, can anyone post me a pic of where to put the pin? I take it it dont need to remove the 3 bolts to put the pin in place?
 
the pin will want to be inline with center top of pump you will need to hold it with a spanner on large nut
 
You must log in or register to reply here.

Similar threads

D
Is My Injection Pump Phucked ?
Replies
12
Views
984
dogdog1
D
R
200 tdi timing
Replies
11
Views
2K
lynall
L
W
200 Tdi crank damper mount shot - what to do
2
Replies
38
Views
2K
wileycat
W
B
Freelander 2 (LR2) Non starter, help please
2
Replies
28
Views
2K
steveemmo
S
M
19J timing case on 12L discovery engine
Replies
4
Views
1K
lynall
L