pete12345

Well-Known Member

• Dec 4, 2020

• #1

How can I test the wiring that goes to to the rear height sensors as one isn’t working properly and it’s new any tips greatly appreciated either with a nanocom or multimeter

 

kermit_rr

Very

Full Member

• Dec 4, 2020

• #2

Can you measure the resistance of the height sensor? It could be duff?

 

oakey

Well-Known Member

Full Member

• Dec 4, 2020

• #3

Unplug it and spray contct cleaner on plug and socket a few times

 

Mark Piercy

Well fumbled member....

Full Member

• Dec 4, 2020

• #4

Swap em over Pete!

 

RangeRoller dt

Well-Sprung Member

• Dec 5, 2020

• #5

Use fly leads that reach to the ends of where you want to test for continuity.
Whole length of the vehicle if you need, follow the loom

 

pete12345

Well-Known Member

• Dec 5, 2020

• #6

Thanks for suggestions the swapping over bit shouldn’t come into it because there both new and that left side was throwing a fault before I replaced them so will check the wire and clean up

 

RangeRoller dt

Well-Sprung Member

• Dec 5, 2020

• #7

Oh sorry , I meant the wiring running to the sensor along the chassis.

 

pete12345

Well-Known Member

• Dec 5, 2020

• #8

All suggestions appreciated found the problem on rear left sensor plug round wrong way just going to adjust the heights today but all working well now going up/down and in an out thank Christ onwards and upwards next job

 

oakey

Well-Known Member

Full Member

• Dec 5, 2020

• #9

I like the easy ones well done