Callum-d90

New Member

• Dec 7, 2011

• #1

Once again having problems with my landy, after changing one side wheel bearings on the rear I started on the other... Only I can't get the drivers side ( (short) half shaft out! Any suggestions?

 

Pikey

Dummy Ejection Facilitator..

• Dec 7, 2011

• #2

what's the prob Is it not Moving at all?? or it is coming so far and jamming??

 

Callum-d90

New Member

• Dec 7, 2011

• #3

redhand said:

what's the prob Is it not Moving at all?? or it is coming so far and jamming??

Click to expand...

Goes about 4" then jamms when it's free it can be spun freely and isn't bent :s

 

Pikey

Dummy Ejection Facilitator..

• Dec 7, 2011

• #4

Callum-d90 said:

Goes about 4" then jamms when it's free it can be spun freely and isn't bent :s

Click to expand...

Big pry bar.. Sounds like it's damaged and snagging Ya other option is to undo the nuts where the HUb is bolted to the axle case and take the whole hub assembly off in one piece At least that way ya can whack the other end of the half shaft out of the hub.

 

Callum-d90

New Member

• Dec 7, 2011

• #5

redhand said:

Big pry bar.. Sounds like it's damaged and snagging Ya other option is to undo the nuts where the HUb is bolted to the axle case and take the whole hub assembly off in one piece At least that way ya can whack the other end of the half shaft out of the hub.

Click to expand...

Cheers for that will have a bash.

 

[JP]

New Member

• Dec 8, 2011

• #6

this is on the rear right?

 

Callum-d90

New Member

• Dec 8, 2011

• #7

[JP];1724984 said:

this is on the rear right?

Click to expand...

Yeah got it out now, sub axle was f**ked to say the least