ironie

Well-Known Member

• Sep 22, 2018

• #1

I replaced the o\s front bearings several weeks ago and did a quicky (read sloppy) replace of swivel seal
by nipping the new seal and cleaning the landing and rtv'g it in. while cleaning the landing I hooked this out.

I have looked at several good videos and exploded assembly pictures and can't figure out what it is.
it is both too small and insubstantial to be part of the needle-bearing.
Another Landy enthusiast and professional mechanic looked at it and said it might be a cir-clip from the axle but his certainty level was pretty low. Any ideas mates?

 

neilly

Well-Known Member

• Sep 22, 2018

• #2

is there not a spring ring as part of the CV joint retainer?

Cheers

 

neilly

Well-Known Member

• Sep 22, 2018

• #3

Number 5 in this pic.

http://new.lrcat.com/#!/1231/25878/25897/1939

STC 579

Cheers

 

ironie

Well-Known Member

• Sep 22, 2018

• #4

Nailed it! Well done. Thanks.
this didn't show it.
https://www.roverparts.com.au/front_shafts___non_a_b_s__to_ja032850

 

ironie

Well-Known Member

• Sep 22, 2018

• #5

I had a real bitch of a time getting the flange end cir-clip back on when I initially found the sloppy bearing and attempted to snug it up, it went on a lot easier after I replaced them.
I had read the flange bolts are supposed to fit the threading in the axle, but that wasn't the case for me.

 

neilly

Well-Known Member

• Sep 22, 2018

• #6

ironie said:

I had a real bitch of a time getting the flange end cir-clip back on when I initially found the sloppy bearing and attempted to snug it up, it went on a lot easier after I replaced them.
I had read the flange bolts are supposed to fit the threading in the axle, but that wasn't the case for me.

Click to expand...

iirc , I normally use an M8 or M10, it does not screw in, just hold it at an angle and pull the halfshaft, the circlip just pops into place then.

Cheers

 

ironie

Well-Known Member

• Sep 22, 2018

• #7

Ta Neilly. That is indeed what I did. I bet it is an imperial thread.