Hi all,

Can anyone tell me how I can stop the mileage from flashing and correcting the miles after fitting a facelift speedo. The new speedo is about 30k lower than the old one.

Also to turn off the ACE light, I don't have this fitted in my landy.

Both By using Hawkeye

Thanks

John

this may help

http://www.landyzone.co.uk/lz/f8/lynx-diagnostics-260640.html

with hawkeye you can go to Security - BCU - Programming and set to "no odometer error warning" then at the end of the whole list prompt yes for "change factory settings"...you can't modify the mileage with hawkeye if you replaced the instrument pack...for that you need nanocom to synk it with the BCU if you insist to get to the higher mileage stored there

for the ACE light you can't do anything with hawkeye but is that on only on that replacement instrument pack or was it on on the old one too?... the car is originally non-ACE or was it with ACE then converted?

if you are playing with tester in BCU settings maybe you are interested in that too http://www.landyzone.co.uk/lz/f8/recommendation-d2-owners-184078.html

sierrafery said:

for the ACE light you can't do anything with hawkeye but is that on only on that replacement instrument pack or was it on on the old one too?... the car is originally non-ACE or was it with ACE then converted?

Click to expand...

The ACE light is only on the replacement instrument pack, and the landy is non-ACE.

Would it not fail an mot , as its showing a fault, even though I don't have that function ?