Tiny1000

Tiny1000

Active Member
Hello, over the next couple of weeks, I'm stripping a Freelander 2 2007 manual so I can use the engine, as my engine is fried (Freelander 2 2007 Auto). I would like to keep everything from the donor engine as it always starts the first time. So the question is, what would I need to recode? Do I need to record any information from the donor engine before I strip the car? And finally, will the Autel AP200 be capable of doing this? Thanks in advance for any help
 
Hi,

So you have one working FL2 with manual gearbox that you want to split in many parts ?

And you have FL2 with dead engine and auto gear box.

Save your time, use the FL2 which is working. You will end up certaintly switching the engine back once the auto gearbox has gone.
 
Last edited:
Tiny1000 said:
Hello, over the next couple of weeks, I'm stripping a Freelander 2 2007 manual so I can use the engine, as my engine is fried (Freelander 2 2007 Auto). I would like to keep everything from the donor engine as it always starts the first time. So the question is, what would I need to recode? Do I need to record any information from the donor engine before I strip the car? And finally, will the Autel AP200 be capable of doing this? Thanks in advance for any help
Click to expand...
You'll need to change is the injector codes in the ECM. Also if you want to avoid doing an air path calibration, you'll need to use all the intake sensors from the working engine.
I'm not sure the Autell will do either the injector code change or the air path calibration.

Don't forget to order new drive/flex plate bolts for when you do the engine swap.
 
You must log in or register to reply here.

Similar threads

M
2007 Freelander 2
Replies
7
Views
511
andyfreelandy
andyfreelandy
A
Immobiliser
Replies
2
Views
446
Freddie17
Freddie17
J
Freelander 1 Engine removal
Replies
8
Views
1K
Alibro
Alibro
J
Oil leak
Replies
1
Views
250
Anaconda
A
M
Freelander 2 (2012) Reduced Engine Performance
Replies
7
Views
2K
Swann36
Swann36