Hi, The landy I have purchased had a 2.5 NA diesel motor, after removing it to replace with 200tdi I've noticed it was once a petrol; the engine mounts that are on it are round petrol mounts although someone has moved one of them to put in the diesel, I see that diesel mounts are square and look stronger, do you think it is worth the trouble to replace them with square ones or just keep the round ones. Thanks Terry

round ones work fine for a 200tdi

big cast iron front crank pulley ??

be aware that it can strike the front axle tube quite hard on compression..

my cure for that was to turn the rear Vee off the pulley and use two thick washers on each engine mount to assist lifting the engine 1/4"



after sticking it on my lathe