Hello, I've been trying to get my 2.25 petrol engine running sweet. However when using a strobe to check the timing, it will only run when advanced past the timing marks. Ive fitted an electronic ignition and a new distributor as well as a new coil. I put the advanced timing down to better fuel and the refreshed ignition system.
I put the compression tester on just for peace of mind.
Cylinder 1 50 psi
Cylinder 2 50 psi
Cylinder 3 50 psi
Cylinder 4 0 psi.
So with all the above information where to start.
I put the compression tester on just for peace of mind.
Cylinder 1 50 psi
Cylinder 2 50 psi
Cylinder 3 50 psi
Cylinder 4 0 psi.
So with all the above information where to start.