Davlyn

Active Member

• Oct 17, 2012

• #1

Evening all,
Has anybody replaced the door check strap pins on their P38? A couple of mine seem to have worn quite badly so I was thinking of replacing them. Do they just push up through?

regards,

Dave

 

Datatek

Well-Known Member

• Oct 18, 2012

• #2

They look like roll pins on mine, I reckon they would be buggers to get out. If you do get them out replace them with a S/S bolt. You may find that it's not the pin that's worn but the hole in the strap.

 

Last edited: Oct 23, 2012

S

sandyt

Well-Known Member

• Oct 18, 2012

• #3

They are roll pins so yes tap them out as Data says on mine it was the holes not the pins ie the pins were ok but the holes had elongated

 

V

V8HSE

Member

• Oct 22, 2012

• #4

Replaced both front door check-strap brackets on my P38 as they were worn ( elongated holes ) causing a cracking/click noise when doors were opened... only a couple of £'s each from an Indy LR dealer ... colour-matched /painted with an aerosol can and fitted in 5 mins... job done

 

Davlyn

Active Member

• Oct 22, 2012

• #5

I had a quick look at mine at the weekend and I think your right its the check strap that have worn.
Your link takes me to a check strap for a Vauxhall Vivaro??
Can you give me a basic break down on how you did the job, it look awkward to me so I would appreciate your comments,

regards,


Dave

 

V

V8HSE

Member

• Oct 23, 2012

• #6

On may car it was the brackets which were worn-out... tap out roller-pins and remove/replace brackets, refit pins through check-strap ..voila...job done

 

Datatek

Well-Known Member

• Oct 23, 2012

• #7

Just take the bits off and if not broken drill the holes out and fit a larger diameter pin (or bolt)

 

Davlyn

Active Member

• Nov 3, 2012

• #8

Picked up some new roll pins and brackets yesterday, sprayed the brackets last night so ready to do the job.
My only question is how do you get the new roll pins in, are you supposed to just knock them down through?

Thanks,


Dave

 

The Mad Hat Man

Well-Known Member

LZIR Despatch Agent

• Nov 3, 2012

• #9

Yes.

Yu could use a pin punch.

 

Davlyn

Active Member

• Nov 3, 2012

• #10

Forget my last question, I have just taken one of the pins out of the packet and seen that they are tapered.

thanks anyway,

Dave

 

Datatek

Well-Known Member

• Nov 3, 2012

• #11

Davlyn said:

Forget my last question, I have just taken one of the pins out of the packet and seen that they are tapered.

thanks anyway,

Dave

Click to expand...

I press them in with a little clamp