Hello together,

so far, I three times installed a cruise control in a Defender.
They all work fine.

But, during installation yesterday I recognized a situation, that I cannot explain to me.

When I put the Nanocom to my car, the clutch switch is in position ON when the clutch is not pressed. OFF when using the pedal.
When I take the plug of the switch, the NC says OFF, if I bridge the plug it says ON again.

At the Ninety of my friend it is exactly the other way round!

Not pressing the clutch, the NC says OFF, pressing ON.

I had to install a additional switch, to tell the ECU the clutchswitch is on ON, that the cruise is working.
Prob. there is somewhere a shortcut?

Is here anybody who can explain that?

Regards

Horst