discoverydti

Member

• Nov 10, 2013

• #1

Hi Guys the rear wings of my 96 Disco where the mud flap plate attaches have corroded badly so I'm going to chequer plate the whole lower body and found these http://www.island-4x4.co.uk/chequer-plate-side-protection-alloy-lrd304-p-5273.html are they any good and will they fold back to strengthen the rear wing.

 

Last edited by a moderator: Nov 10, 2013

bankz5152

Well-Known Member

• Nov 10, 2013

• #2

Page not found.

 

pontyslapper

Brought a Landy to LZ11. Yay!!

• Nov 10, 2013

• #3

Try it again, but go to the address bar and take off the extra comma at the end or just click below...

Chequer Plate Side Protection (Alloy) LRD304 Island 4x4 - Specialists in Land Rover and Range Rover Parts and accessories for all models. UK and worldwide mail order.

 

blue beasty

Leaks an prone to bits dropping off

• Nov 10, 2013

• #4

bankz5152 said:

Page not found.

Click to expand...

Try it now

 

blue beasty

Leaks an prone to bits dropping off

• Nov 10, 2013

• #5

I use chequer plate to strengthen up panels (wing tops) but I'm not a big fan. The problem as I see it is yes you can tidy up areas but then you have no idea what is going on underneath........esp with a disco that have a distressing tendancy to rot from the inside out

At the vey least you'll need to thoroughly treat corrosion before covering it up, seal the plate so it doesn't trap water behind and use fixings made from the same material as the panel

 

DiscoNickY

New Member

• Nov 10, 2013

• #6

I've just finished my new chequer plate floor today....

 

Attachments

• 
  image.jpg

  974.4 KB · Views: 300

MGBGTV8

Active Member

• Nov 10, 2013

• #7

Have you thought about just renewing the whole wing?
It's not too bad a job - the hardest part is finding decent replacement parts unless you fancy handing over circa £1k for new panels!

It's also a prime opportunity to assess the quality of your inner wings and repair as necessary.

 

landowner

Pensioner Pete

Full Member

• Nov 10, 2013

• #8

DiscoNickY said:

I've just finished my new chequer plate floor today....

Click to expand...

Why did you turn Disco in its side

 

blue beasty

Leaks an prone to bits dropping off

• Nov 10, 2013

• #9

landowner said:

Why did you turn Disco in its side

Click to expand...

Cause he wouldn't have got it all in the picture otherwise.....ffs some people!