Hi all. Just bought a spare key to my Disco and tried the key programming with Nanocom but without any luck. I am doing the whole programming but at the end there is still information NOT DETECTED. Old key works 100% fine, locks and unlocks the car so the RF is working fine. As well I have tried to code new key i other Disco 2 which worked. Any ideas? Is that a BCU fault?
sierrafery
Well-Known Member
Hi. Try in slot 3 if in 2 didnt work
Bantam1
Well-Known Member
Don't know for certain but do you need to clear a slot first?
Seems an age since I did mine but I think I did a bit of tidying up of the codes at the same time.
Have you looked at the Nanocom site for walk through?
https://www.nanocom-diagnostics.com/
Seems an age since I did mine but I think I did a bit of tidying up of the codes at the same time.
Have you looked at the Nanocom site for walk through?
https://www.nanocom-diagnostics.com/
Bantam1
Well-Known Member
sierrafery
Well-Known Member
As long as the other fob works and the new fob is detected by other vehicle then the BCU becomes very suspect
I think I have found the problem. It looks like the RF Receiver isn't working as it should. If I go to the front of the car, it doesn't won't to open it, but when I lift my hand up or get it closer to the sunroof it works. Is there any way to clean it or make it stronger or should I just replace it?
