Latest activity

.... lost my locking wheel nut socket thing on my gravel drive, big gravel so made it worse. I raked the gravel all over and back sifted through it, nowt. About 3 years later I was doing a job on the same car and looked around, there it was...

Is that it!! My old chassis makes that look brand new!

Should I remove this thread from my watched selection?

Flippin hot today again, not doing much.

Nanocom for diagnostic.

I fort it were aaan oxymoron, I'd berrer look it oop!! Edit, stoopid link no workee, but said "dichotomy is two separate things contradicting themselves, oxymoron = words or phrases that contradict themselves. " So one is words and tother is...

I am sure this will be no surprise but I seem to have random volume control on stereo from either unit dial or steering wheel controls but not necessarily the same result from both! The sat nav has a mind of it's own but at least the hvac seems...

Don't give other parts to replace!!!! 😉 Just finished to put the cubby box in, looks good with the matching front seats, well it will once I removed all the bits and pieces on the seats! Not bad for a lunch break. Dashboard removal next, after...

And never be your own customer!

I see. There is always a trick to every bit of gadgetry! Although I drive lots of different modern crap at work my present daily car is a 1977 daimler with the only electronic bit being a replacement distributor!!!

Where do you park yer horse lol

If you use just the rocker switch on its own you can only choose elevated, normal or access height. Pressing the lock ride height button first will then allow the highway ride height to be selectable.

Never count the expense unless it's a clients😜

many thanks for a quick answer I will try that as using the rocker switch on its own wouldn't pick motorway height although you probably knew that! I have so much to learn.

I have done mine's intermediate shaft front O ring seal as above. Moved trans box back on two extra long bolts and then push shaft forward just enough to renew the O ring.

Hi, contact THIS GUY

Press the lock height button then with this done, press down on the rocker button and it’ll go to m/way height instead of access height. Pressing again will put you down to access height. While the lock height switch is pressed it will remain...

Lmao you guys solder them and the like, my emergency fix is strip back wire, twist and tape hahahah!

Ah, the yet unwritten future! Did I think about that the last days, or rather weeks! Anyway, the plans changed, mainly due to budget and credit card limits. First, things that didn't change: She will be used for a one week trip to Corsica to...

Hi, Had issues with water in the engine bay fuse box after leaving the bonnet up in a monsoon! Struggled with the horn, abs motor and air pump operating randomly due to water lying in the fuse box. I've stripped it out and one of the harness...

Why don't you post up the advert so we can help better? Intermediate shaft o-ring can be changed with the transfer box still in the vehicle, almost, just about. I have done it twice, although you do have to release the box and slide it back a bit.

Sorry to butt in but how do you lock suspension at motorway height as on first rangey and handbook quite knackered. On the polybush bit I have found parts that rotate more than a few degrees seem to wear polybushes rapidly even when using correct...

Morning All. :D I had a lie-in. :) Have a great day! :D

I'd probably buy it on that observation. The chassis protection system can be repaired easily enough.

no sorry my mistake, it bubbles only with the compressor running . Doesn't bubble with it off.

I attended my local meet last night, only a few miles from home. Some other owners had travelled an hour or more to attend. It was a nice relaxed meet up with a variety of land rovers.

Did not think of that. I will take a look.

been there done that spent 3 days looking for it, found it 4 years later still stuck under a hose along with a 10mm socket i lost the year before