Waste gate control valve

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
E

engineer

New Member
Posts
166
Is it neccessary to have the vacuum side of the valve connected i asume it is to open the gate should the inlet get slightly blocked however i would prefer to connect the pressure pipe direct and eliminate the valve.


Engineer:):)
 
Indeed it does but my question concerns the valve controling the pressure that is fed to the actuator cylinder perhaps i should mention this is on a td5.


Engineer:):)
 
I was under the impression that the engine ECM sent a signal to the regulator / valve to open or close the wastegate. Bypassing this would render the turbo redundant as there would be little if any boost I think.
Regards
 
You must log in or register to reply here.

Similar threads

rover75lover
L322 air suspension valve
Replies
0
Views
322
rover75lover
rover75lover
Simon Perks
Disco 2 The waste gate conspiracy (hehe)
Replies
1
Views
317
sierrafery
sierrafery
D
Discovery 2 ACE - DTC 33 Directional control valve fault.
Replies
9
Views
1K
DaryllD2
D
Montyjohn
P38A EAS Inlet Valve Stuck or leak?
Replies
7
Views
1K
Montyjohn
Montyjohn
5
Loss of power & slight misfire
Replies
11
Views
1K
Arctic2
Arctic2
Back
Top