daz haynes
New Member
- Posts
- 3
hi does anyone know where to get the vac advance pipe from to fit a 3.9v8 disco tried the dealers who said it was discontinued
vac pipe
- Thread starter daz haynes
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
discopaul
New Member
- Posts
- 571
- Location
- Chesterfield
you can get Silicon Vac pipes from eother E bay or Hafords sell it in there Rip speed section. all you need is silison pipe. Though it can be expensive
1992lse
New Member
- Posts
- 861
- Location
- ontinyent spain
try these guys
01707665588. but if its the same as a rangie
then any car spares shop will cut you a length
of vacuum pipe
daz haynes
New Member
- Posts
- 3
sorry for the confusion the pipe itself is ok the rubber ends are split(both ends)
fett
Well-Known Member
- Posts
- 8,637
- Location
- South Hampshire
Cut em off and push em back over 
stchris356
New Member
- Posts
- 684
- Location
- Warwick,UK
Mine split, took it off and went down to local breakers and found one on an old Toyota that was a lot longer, pulled the end off and cut it down and fits a treat, and it was free
bushwwacker
Well-Known Member
- Posts
- 6,154
- Location
- Here
try your local independant motor shop, (NOT the chavved up corsa type) they should have the bits in.
1992lse
New Member
- Posts
- 861
- Location
- ontinyent spain
fett
Well-Known Member
- Posts
- 8,637
- Location
- South Hampshire
No, thats wipe it off and put it back in lol
t it back in lol
