hunterandthehunted
New Member
- Posts
- 224
is it possible to display the internal temp instead of the outside?
temp display 4.6 hse 1995
- Thread starter hunterandthehunted
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 45,024
- Location
- Near Poitiers SW France
Only if you move the sensor
gavbriggs
Well-Known Member
- Posts
- 5,861
- Location
- Sheffield uk
:doh:
hunterandthehunted
New Member
- Posts
- 224
well if you don't know, you don't know.
thanks, i am going to get a hand book from ebay i think
thanks, i am going to get a hand book from ebay i think
SpudH
Well-Known Member
- Posts
- 1,256
- Location
- County Kerry, Ireland
Forget ebay, just get the Rave download, the manual is in it.
gavbriggs
Well-Known Member
- Posts
- 5,861
- Location
- Sheffield uk
i know there is a sensor inside, beneath the clock. i'd like to know where the external sensor is though, i think mine is ferked cos it said 35 degrees today!!! unless its wedged on the head i dont think sooooooooooooooo!
Datatek
Well-Known Member
- Posts
- 45,024
- Location
- Near Poitiers SW France
Not sure where the external sensor is on your V8, but on the diesel, the temperature reading goes up when the car is stationary with a hot engine.:doh:
gavbriggs
Well-Known Member
- Posts
- 5,861
- Location
- Sheffield uk
on the v8, the revised position is on the air con condensor front left, dunno about my 96 style. its prolly not the revised edition!!!
i assume they revised it due to the rediculous readings it gives!!!!
it'll have a look at some point!!!
i assume they revised it due to the rediculous readings it gives!!!!
it'll have a look at some point!!!
