TD5 new clutch kit installed but now screeching noises!!!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
D

discoMatt90

New Member
Posts
8
Location
Chesterfield
Hi All, I've taken the disco TD5 to a "recommended landrover garage" to have a new clutch fitted to include the release bearing etc as well as a service. It previously has a tendency to slip for a day or so then not slip for a week or two...weird.
After getting it back from the garage and driving for a couple of days it started to "screech" quite loud when depressing the clutch pedal. I took the car back to the garage and typical it didn't make a sound as we drove around during a test drive. To be honest i was fobbed off with a statemennt "it will be a brass bush wearing in"
It now is constantly making the noise and it sounds catastrophic! anyone got any ideas before i take it back again? Have i been duped? Any help would be appreciated........
 
tiz likely to be either clutch release bearing or spigot bush.

My answer is "is this normal?" if the answer is "no" then take it back. It is possible that the spigot bush wasnt lubricated prior to fitting.
 
Just looking at the invoice:
parts used for the clutch, FTC4630 CLUTCH COVER PLATE, FTC4631 CLUTCH PLATE, FTC5200 RELEASE BEARING, 8566 BUSH FLYWHEEL

Johnlad, Is "8566 bush flywheel" the spigot bush your refering to?
Thanks for all the help......
 
I had mine done recently at a main dealer. The land rover part number for the spigot bush is LFB500050 (i.e. land rover genuine factory part). I think the reference to 8566 BUSH FLYWHEEL is a Bearmach part number for the same thing.

Anyway they seem to have changed the spigot bush and the release bearing (FTC5200 is the LR genuine part number) so it must be down to them. Take it back and complain. Good luck.
 
You must log in or register to reply here.

Similar threads

MuddyMat
Disco2 2004 TD5 clutch misbehaving
Replies
5
Views
812
MuddyMat
MuddyMat
Cornishdefender
Clutch pedal travel suddenly changed - now bite point in last 2 inches towards floor
Replies
4
Views
440
Cornishdefender
Cornishdefender
G
Land Rover 300tdi clutch not disengaging after engine out
Replies
8
Views
2K
miktdish
miktdish
H
Discovery TD5 engine starts shaking occasionally when started
2
Replies
39
Views
2K
sierrafery
sierrafery
Globetreka
300Tdi or Td5?
Replies
2
Views
428
tottot
tottot
Back
Top