P38A SRS airbag fault - Nanocom code 065 - SOLVED & fixed!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
M

Mukiwa

Well-Known Member
Posts
469
Location
Winsford, Cheshire, near Oulton Park
Hi guys,
I have changed the rotary coupler for an flea bay special as after reading many of these SRS posts it's mostly the rotary coupler that's the problem. I have searched on here and no code 065 specific posts that I can find.
Nanocom gives me this code now:

CODE 065
INVALID FAULT CODE
(PERMANENT)

Any ideas please? I will check the underseat connectors and passenger airbag tomorrow. This all started when I moved the steering wheel column adjuster as the wheel was too low.
Can't put it through the MOT until I get this fixed.
 
I had a fault on my nanocom showing as (if I recall) left hand blend motor fault something or other plus temp sensor failed. This meant my blend motors had jammed in the windscreen demist position - luckily for me this time! Nanocom wouldn't reset the blend motors it could only turn the fans on and off.
So...... can someone please explain how replacing the blown SRS fuse in the dash suddenly made the blend motors start working again? How on earth can one affect the other? :confused:

Anyway I'm happy now as the blend motors have moved for the first time in 9 months, I just need to get a new condensor and gas her up and inshallah A/C should now work!

MoT this afternoon so fingers crossed :p
 
Mukiwa said:
I had a fault on my nanocom showing as (if I recall) left hand blend motor fault something or other plus temp sensor failed. This meant my blend motors had jammed in the windscreen demist position - luckily for me this time! Nanocom wouldn't reset the blend motors it could only turn the fans on and off.
So...... can someone please explain how replacing the blown SRS fuse in the dash suddenly made the blend motors start working again? How on earth can one affect the other? :confused:

Anyway I'm happy now as the blend motors have moved for the first time in 9 months, I just need to get a new condensor and gas her up and inshallah A/C should now work!

MoT this afternoon so fingers crossed :p
Click to expand...

Every so often (once a week) change the temp from LO for a minute or two to HIGH for a minute or two and then back to whatever you usually have it. Seems to help keep them free.
 
Mukiwa said:
Solved!!!!!!!!!! Second blown bulb in the display! So therefore......
CODE 065
INVALID FAULT CODE
(PERMANENT)

= ONE of your SRS bulbs is not working :D:D:D
Click to expand...

Maybe you should post this info on the Nanocom Forums, and hopefully they will add it to the next software release ?
 
You must log in or register to reply here.

Similar threads

R
Disco 2 Srs light
2
Replies
29
Views
3K
Stanleysteamer
Stanleysteamer
W
P38 SRS/Airbag Fault
Replies
8
Views
1K
Mark Piercy
Mark Piercy
Soir
P38A SRS + Airbag Fault + Nanocom unable to communicate with ECU
2
Replies
22
Views
3K
Datatek
Datatek
MikeFl4
P38A ABS faults and codes
Replies
17
Views
2K
MikeFl4
MikeFl4
FlatbedPilot
Disco 2 Nanocom fault codes for wheel sensors.
Replies
15
Views
2K
Stanleysteamer
Stanleysteamer
Back
Top