Series 3 gearbox in Series 1
- Thread starter Stacey007
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
tottot
Well-Known Member
- Posts
- 8,073
- Location
- west wales coast
What wheelbase?
Hicap phill
Well-Known Member
- Posts
- 16,319
- Location
- Wiltshire
Also what engine?
Hicap phill
Well-Known Member
- Posts
- 16,319
- Location
- Wiltshire
You will have to make/cut part of the bulkhead to allow the slave cylinder on the gearbox.
What engine are you using?
Rangieman123
Active Member
- Posts
- 122
- Location
- Dublin, Ireland
From memory, your 86'' has a solid shaft clutch release mechanism from the pedal. So no hydraulic clutch.
You would need to keep your original bellhousing but I don't know for sure if it will correctly fit to a Series 3 gearbox.
You would need to keep your original bellhousing but I don't know for sure if it will correctly fit to a Series 3 gearbox.
Rangieman123
Active Member
- Posts
- 122
- Location
- Dublin, Ireland
or you could convert to hydraulic clutch.
tottot
Well-Known Member
- Posts
- 8,073
- Location
- west wales coast
OR it is possible to fit a series 3 box with the bell housing/clutch unit from a 2/2a box
Hicap phill
Well-Known Member
- Posts
- 16,319
- Location
- Wiltshire
Yep that’s what I done.on 80”pedals through the floor
Now where do the pedals come from on the 86…. Through the floor or top of the footwell?
