rust proofing

mark86_02 · Aug 24, 2006

Hi everyone i have just had my series 2a chasis welded and jus wondered if anyone could offer any advice on rust proofing, the chasis thanks Mark

Slippery · Aug 24, 2006

I too would be interested the out come of this thread and all I can say is “Don’t forget the inside of the welded sections where the oil has burnt off”

Slippery

mark86_02 · Aug 24, 2006

How do ya mean the inside of the weld sections ???? how do ya gain access to the insides lol im clueless about this subject -sorry-

cheers

Mark

Slippery · Aug 24, 2006

Bits of you chassis is box section and if you have welded anything to this you would have burnt off any oil / protection there (it gets hot on both sides you know)

I suspect that everyone will suggest Waxoil.
A real messy job

Slippery · Aug 24, 2006

Ps
I DON'T suggest drilling holes in your chassis but a hole can usually be found somewhere

mark86_02 · Aug 24, 2006

ok i get ya now lol and im sure there will be a hole in my chasis somewhere

mark

Wesley Pegden · Aug 24, 2006

Waxoyl, Messy but effective !!!

Regards WP.

mark86_02 · Aug 24, 2006

ok thanks can ya write it any bigger tho i am aving trouble reading that

Wesley Pegden · Aug 24, 2006

mark86_02 said:
ok thanks can ya write it any bigger tho i am aving trouble reading that

Only joshing old bean, waxoyl is about the best bet I reckon. It's low cost and if you do the job over a cheap tarp you shouldn't leave a mess. Once it's on, best leave it to "go off" for a couple of days then it shouldn't drip with the heat from the exhaust.

Regards WP.

rust proofing

mark86_02

New Member

Slippery

New Member

mark86_02

New Member

Slippery

New Member

Slippery

New Member

mark86_02

New Member

Wesley Pegden

Well-Known Member

mark86_02

New Member

Wesley Pegden

Well-Known Member

Similar threads