rotor screw

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

zefrench

Active Member
Posts
428
Location
Ontario, Canada
Hi from Canada!


I wanted to start this post by thanking everyone for the numerous problems and solutions posts. Saved me a lot of time. (I had the read knocking noise, fixed by changing the rear differential mount, and noise on the front on one side, fixed by changing the sway bars (I think some call them drop links)


I always beleive in being over prepared before preparing a job. I watched some youtube videos to get an idea if the freelander disk brakes has anything special and noticed rotor screws.



I look in microcat, and found this information:

SF106121
M6 x 12mm


First it appears this screw is sloted but looking at the video, the one shown is Phillips head.

Finding this screw without costing me an arm and leg got me thinking about the fact that some Honda and Acura have the same sort of screw for their rotors.


The Honda/ accura version is Phillips head. Both appear to be contersunk heads (flat heads).


Honda part 93600-060140H
M6 x 14mm

The honda part is 2mm longer. Will it be a problem, to use a longer screw?


Thanks for your time
 
Is that the screw holding the rotor to the hub? if it is you don't need it, it was there for when it was going down the assembly line, to the next station so it wouldn't fall off
 
Back
Top