Revs limited

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

vessel

New Member
Posts
13
Just had to power pack jump start my defender. Drove ok for two miles and then was left at just over idle to help charge the battery. 20 minutes later there appeared to be a slightly higher tappet noise from the engine and it wouldn't rev to any height at all and i've had to limp back to home.

Any ideas please.

Mark
 
I ain't got a clue why that would allow the engine to still run at lower revs. I made it home, but at a trundle.
 
There's definately a throttle cable as i've revved the engine from under the bonnet using it.

The engine did rev when throttle pressed down, but revs wouldn't climb significantly.
 
To let you know, the throttle cable is located to the left of the engine coming out of the pedal box. If you follow the cable to find the linkages and check them.
Hope this helps.
 
Too late and too dark to go check the motor at the roadside. That and the fact it's minus 6 here just now.
 
Had another look this morning and even using the carb itself to rev the engine, it won't climb above a certain point and what sounds like some kind of relay, (a high tappet noise), is not happy and seems to be inhibiting the revs from climbing.
 
Ok guys, not the carb, the throttle linkage to the engines fuel supply. We don't all work on landrovers, some of us just own them for other needs.
 
Back
Top